background image

Warnings

An AIS receiver and the 

AIS

WatchMate

 work in conjunction with other vessels and 

systems such as transponders and GPS. The accuracy of this device and the AIS 

system can be affected by many factors, including equipment failure or defects, 

environmental conditions and incorrect installation, handling or use. Vesper Marine 

does not warrant that this product is error-free. It is the user’s responsibility to 

exercise common prudence and navigational judgement. This device should not be 

relied upon as a substitute for such prudence and judgement. Always maintain a 

permanent watch so that you can respond to situations as they develop.
The prudent mariner will not rely on a single aid to navigation. The user should 

verify the information obtained from the 

AIS

WatchMate

 is in accordance with 

expected situations and conditions. The information is not guaranteed to be accurate 

or reliable and an AIS receiver and the 

AIS

WatchMate

 are not a substitute for proper 

seamanship.

Vesper Marine Limited cannot be held liable for any injury, damage or loss, 

caused by, during, or because of the installation, use or inability to use this 

device. The 

AIS

WatchMate

 is to be installed and used entirely at your own risk. 

By installing and/or using the 

AIS

WatchMate 

you fully accept this risk and 

agree to hold Vesper Marine Limited harmless.

Take care when cleaning to avoid damage:

  Be careful when wiping the display screen to avoid scratching. Use a clean 

soft damp cloth.

  Do not use acid, ammonia, solvents or any abrasive products.

Trademarks and Copyrights

AIS

WatchMate

 is a registered trademark of Vesper Marine Ltd. All other product 

names are trademarks or registered trademarks of their respective owners.
Copyright © 2008, Vesper Marine Ltd.
Unless otherwise indicated, all documentation and operating software contained 

within this product or distributed with this product is copyrighted by Vesper Marine 

Ltd. All rights are reserved.

Vesper Marine Ltd.
Westhaven Drive, St. Mary’s Bay

PO Box 91164, Victoria Street West
Auckland 1142
New Zealand

+64 9 950 48 48

www.vespermarine.com
[email protected]

WM650-C3.5-0901

Summary of Contents for WM650 WatchMate

Page 1: ...peed or farther away than a specified range Use setup to establish filters for the current profile Setup To change alarm and filter settings associated with a profile you must select the profile prior to entering setup mode Setup mode is accessed from the main menu vespermarine AISWatchMate Getting Started Guide CPA Closest point of approach in nautical miles The nearest a target will come to your...

Page 2: ...on and no setup options need to be changed If you connect a transponder to port 1 instead of port 2 you must use setup to change the device output type for port 1 to Transponder VHF Antenna GPS AIS Receiver or Transponder Optional computer or chart plotter AISWatchMate Port 1 Port 2 38400 baud 38400 baud Configuration Each serial port can be configured for input output or both Port configuration i...

Page 3: ...ional computer or chart plotter GPS AISWatchMate Port 1 Port 2 38400 baud 38400 baud 4800 baud External alarm wiring To control an external alarm buzzer or indicator use the orange and black wires They are normally open and become switched together whenever the internal alarm is sounding Do not exceed 2 amps It is recommended that you install a fuse to protect against over current Routing output d...

Page 4: ...ute for proper seamanship Vesper Marine Limited cannot be held liable for any injury damage or loss caused by during or because of the installation use or inability to use this device The AISWatchMate is to be installed and used entirely at your own risk By installing and or using the AISWatchMate you fully accept this risk and agree to hold Vesper Marine Limited harmless Take care when cleaning t...

Reviews: