2(8)
Sonde PL18-05
The serial number of your device is indicated on your Sonde and on the storage
case. The serial number may wear off, enter the serial number below and always
refer to this information when you need to contact the manufacturer.
VERSION NUMBER
X0.2-C
SERIAL NUMBER
___________________________
IMPORTANT SAFETY INFORMATION
The following symbol is used throughout this manual mark important instructions.
Please take care when meeting this symbol:
GENERAL INFORMATION
The Sonde PL18-05 is highly powerful, battery-operated small transmitter that emits
a 512 Hz signal, which can be located by a receiver operating on the same
frequency. The Sonde is intended to be used in both conductive and non-
conductive ducts, cavities and structures. The device is intended for professional
use.
ITEMS SUPPLIED
1
Sonde Transmitter
PL18-05
1
Lithium Battery
LS14250
1
Battery compartment with female M12 thread
PL18-M12F
1
Battery compartment with male M10 and female M6 threads
PL18-M10M
1
Case with quick reference guide
SB18
BATTERY INSTALLATION, TURNING ON AND OFF
Figure 1: Inserting battery
Insert an LS14250 battery. Observe polarity (Figure 1). To turn the PL18-05 on, tighten
the battery compartment. The LED at the tip of the Sonde will start flashing. Take
care to fully tighten to avoid water getting into the device. To turn the Sonde off
unscrew battery compartment. Always remove the battery completely when you
are not using the Sonde.
When the battery has insufficient capacity left for carrying out measurements, the
LED will turn off. Replace the battery. Low temperatures reduce the operating time
of the battery.
LS
14250
