2(8)
MicroSonde VMS6-33
The serial number of your device is indicated on your MicroSonde and on the
storage case. The serial number may wear off, enter the serial number below and
always refer to this information when you need to contact the manufacturer.
VERSION NUMBER
X00-C
SERIAL NUMBER
___________________________
IMPORTANT SAFETY INFORMATION
The following symbol is used throughout this manual mark important instructions.
Please take care when meeting this symbol:
GENERAL INFORMATION
The MicroSonde VMS6-33 is small battery-operated transmitter that emits a 33 kHz
signal, which can be located by a receiver operating on the same frequency. The
MicroSonde is intended to be used in non-conductive ducts, cavities and
structures. The device is intended for professional use.
ITEMS SUPPLIED
1
MicroSonde transmitter
VMS6-33
2
Lithium battery
BR535
1
Battery compartment with female M5 thread
VMS6-M5
1
Case with quick reference guide
SB9
BATTERY INSTALLATION, TURNING ON AND OFF
Figure 1: Inserting battery
Insert a BR535 battery. Observe polarity (Figure 1). To turn the VMS6-33 on, tighten
the battery compartment. The LED at the tip of the MicroSonde will start flashing.
Take care to fully tighten to avoid water getting into the device. To turn the
MicroSonde off, unscrew battery compartment. Always remove the battery
completely when you are not using the MicroSonde.
When the battery has insufficient capacity left for carrying out measurements, the
LED will turn off. Replace the battery. Low temperatures reduce the operating time
of the battery.
