5
9510-1236 Rev -
9-15-14
Pipe Sensor:
A pipe sensor can be used to determine whether there is hot or cold
water in a two pipe system. To activate the pipe sensor, install as
shown and then see programming instructions.
Mount the pipe sensor to the water pipe. The best location is to be as
close to the main pipe as possible and attached before the water valve
connection.
Water
Main
Valve
Sensor
Wire
Ties
Refer to the programming instructions for selecting the pipe sensor
function, temperature changeover settings, output configurations, purge
frequency and purge time duration. The thermostat will monitor pipe
temperature every 5 seconds. For a valveless systems, select the
2Pn
configuration setting since this will bypass the valve purge
functions and provide heating or cooling based on pipe temperature
alone.
The
2PS
and
2PE
configurations operate with a valve purge function
to prevent incorrect temperature readings from static or standing water
in the pipe. The valve purge operates on a programmed interval
(purge frequency) for a programed duration (purge time duration)
in the event of low activity over an extended period of time.
If the heat or cool call has lasted for more than three minutes, the
pipe temperature heat or cool mode is rechecked to verify proper
operating mode.
Pipe Sensor
Blue/white wire
Green wire
Contains FCC ID: SZV-STM300U
Contains IC: 5713A-STM300U
The enclosed device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two conditions:
(i.) this device may not cause harmful interference
and (ii.) this device must accept interference received,
including interference that may cause undesired
operation.
Verve LS &
PSG Controls, Inc.
LIMITED WARRANTY POLICY
PSG Controls, Inc. (Hereinafter referred to as "PSG") warrants the following:
Only cataloged products sold to distributors are warranted to the original purchaser, to
conform with specifications furnished or approved by PSG, and to be free from defects in
material and workmanship, for a period of one (1) year from the date of purchase, unless
specified in writing for a different period.
Any PSG product that proves defective within the above described warranty period will
be repaired or replaced (at PSG's option) free of any charge if returned to the PSG
factory at 1225 Tunnel Road, Perkasie, PA. 18944 with transportation charges prepaid.
Prior to returning this product to PSG, the purchaser shall give PSG notice in writing
stating how this product fails to fulfill this warranty. No product shall be accepted for
repair or replacement without a required written notice and without prior written
authorization and shipping instructions having been received by the purchaser from
PSG. Only PSG's factory is authorized to perform services under this warranty.
This warranty does not extend to any product that has been subjected to misuse, abuse,
neglect, accidents, alterations, improper installation or use in violation of the printed
instructions furnished by PSG. This warranty neither applies to batteries nor
deterioration of, nor damage to the product caused by the use of faulty batteries. Final
determination as to whether any product is actually defective rests solely with PSG.
This warranty is expressly in lieu of all other agreements and warranties, expressed,
implied, or statutory and PSG has no other obligations or liabilities in connection with this
product. In no event shall PSG's obligation or liability hereunder exceed the purchase
price of this product. PSG SHALL NOT IN ANY EVENT BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES. This warranty gives you specific legal
rights, and you also have other rights which vary from state to state. Some states do not
allow the exclusion or limitation of incidental or consequential damages, or implied
warranties, so the above limitations or exclusion may not apply to you.
Toll free technical assistance is available
via our technical hotline: 1-800-523-2558
Mon-Fri, 8:00 A.M. to 4:30 P.M. Eastern Standard Time
R
PSG Controls, Inc.
