Occupancy Sensor – Ceiling Mounted • Installation Guide
page 2 of 4
Verve™ Living Systems
Coverage Diagrams
Tip:
To provide coverage for very high ceilings, a wall sensor can
be incorporating in the plan for complete coverage.
Installing
estimated time: 20 minutes
The occupancy sensor can be mounted on most ceilings with the
provided screws, or mounted on dropped ceilings, using the
provided wire bracket.
1.
Decide where you want to install the occupancy sensor.
Tip:
For visual alignment, orient the sensor parallel to one of
the walls.
2.
Remove the mounting plate from the sensor.
3.
Decide which of the two installation options is appropriate
.
Screw Mounting Plate to the Ceiling
a. Hold the mounting plate in place on the ceiling and use a
pencil to lightly mark two small dots for the
screw drill
points.
b. Drill two holes with a 3/16” drill bit and insert the wall
anchors.
c. Insert the first screw
loosely and level the
mounting plate.
d. Insert the second screw
and then hand-tighten the
first screw.
Mount Using the Wire Bracket
a. Remove the ceiling tile where you want to mount the
sensor.
b. Place the mounting plate squarely on the ceiling tile and
use the wire to mark two points for the holes.
c. Punch two small holes through the ceiling tile at the
marked points.
d. Insert the wire bracket
through the two holes in
the mounting plate.
Make sure the ends are
roughly even.
e. Feed the wires through the
holes in the ceiling tile.
f. On the front of the ceiling
tile, flatten the wire bracket
so it is snug against the
mounting plate.
g. On the back of the ceiling
tile, twist the wires
together to hold the
mounting plate securely.
h. Replace the ceiling tile.
4.5m
3m
1.5m
5’
10’
15’
Top View
Side View
1’
3.1’ 4.6’
7.5’
9.3’ 10.9’
13.0’ 14.2’
16.8’
0
10’
0
0-1’
3.1’ 4.6’
7.5’ 9.3’
16.8’
14.2’
13.’
10.9’
10’
0
Summary of Contents for VOSC
Page 3: ......
