Vertiv VRC100 Series, Installer/User Manual

Page: 13 / 44

2.1.1 Storing the Packaged Unit
Store the unit in the original packaging in an area protected from excessive dirt, debris, and contact
damage until final installation. Observe the following requirements and the conditions listed in
Table 2.1
below.
• Do not store the unit outdoors.
• Make sure that the unit stands upright.
NOTE: If the total shipment and storage time exceeds 6 months, the unit requires re-calibration for
proper performance.
Condition Requirement
Ambient temperature: –40 to 158°F (–40 to 70°C)
Ambient humidity: less than 95% relative humidity (103°F)
Table 2.1 Storage Conditions
2.2 Unpacking the Unit
All material used to package this unit is recyclable. Please save for future use or dispose of the material
appropriately.
1. Use a utility knife to cut the packing strip from the box.
2. Remove the cardboard box cover, sides, and supports, then remove the paper corners and
corner cushions.
NOTE: You will lift the unit from the wooden pallet when installing in the rack. Leave the pallet in place
until then.
2 Equipment Inspection and Handling
9