Vertiv Ultracab Cross-Connect, Description And Installation Manual

Page: 18 / 26

Vertiv
| Aerial Ultracab Cross-Connect Enclosures (631-201-009) | Rev. F
18
2. Secure the top bracket to the pole with a
5
/
8
-inch through bolt. Level the bracket before tightening the
bolt.
3. Raise the unit using a block and tackle or winch line passed through a snatch block attached to the top
of the sling. Guide the unit during the hoisting operation with a hand line fastened to the bottom pole-
mounting bracket.
4. Place the enclosure on top of the pole-mounted bracket and verify that both brackets on the enclosure
are properly engaged and sitting levelled on the pole bracket (see
Figure 6 ).
5. Secure the bottom pole mounting by drilling a
11
/
16
-inch hole through the pole and using a
5
/
8
-inch
through bolt (see
Figure 7
).
6. Attach the supplied stabilizer bars to the bottom of the enclosure using the supplied "U" clamps, do not
tighten (see
Figure 7 ).
NOTE!
Does not apply for 400 pair size units.
7. Attach the other end of the stabilizer bars to the pole using two
3
/
8
-inch bolts per bar (see Figure 7 ).
NOTE!
Does not apply for 400 pair size units.
8. Tighten all mounting hardware.
Figure 6:
Lifting Brackets and Stabilizer Bars
LIFTING
BRACKETS
STABILIZER
BARS
POLE