3. Click
Export
.
The .txt file is saved to the web browser's default down-load folder.
4. To prepare the file to use for import:
•
Save the file on a computer or network folder.
•
Open the file in a text editor, and un-comment the line containing password/secret data
(remove #).
•
Delete the asterisks (*****), and replace with the password/secret value in double quotes
(").
•
An imported file need only contain the data to add or update, and does not require
comments. Remove (delete) the content that is not needed.
•
Save the edited file.
Importing a Configuration File
An imported configuration file is typically used to back-up the configuration of a card or to configure
many cards for with a common configuration.
If the export file will be used as a back-up, all of the passwords and secrets must be manually restored.
NOTE: Do not import an un-modified file. This could cause a duplicate IP address or other unintended
duplications.
In addition, the import file does not require comments, and needs only the date to update. For example,
you can change only the system name or a network address by editing the configuration file to contain
only those lines.
To import a configuration file:
1. On the Communications tab, select
2. Click
and enter a user name and password.
3. Click
and follow the instructions on the import dialog.
6.7.4 Manually Restarting the Card
1. Locate the small hole on the front of the card that contains the reset button, see Figure 1.1 on
2. Insert a straight, non-conductive tool into the small hole and press-and-hold for 5 seconds.
The card restarts without resetting it to factory defaults. To reset to factory defaults, see
Manually Resetting to Factory Defaults
6.7.5 Manually Resetting to Factory Defaults
1. Locate the small hole on the front of the card that contains the reset button, see Figure 1.1 on
2. Insert a straight, non-conductive tool into the small hole and press 5 times. Each press should
be 1 to 2 seconds long and must be completed within 10 seconds.
The card is reset to factory-default configuration.
CAUTION: Do not press-and-hold the button too long. Pressing and holding for 5 seconds
restarts the card without resetting to factory defaults.
6 Editing the Unity Card Configuration
67
