Vertiv eSure C48/58-1000B, Installation Manual, Page: 28 / 40

Vertiv
| eSure™ Power Extend Converter Mounting Bracket Kit Installation Manual (IM565460) | Rev. A
28
Single Power Extend Converter Installation – Bottom Row
To parallel power extend converters in the bottom row, refer to the procedure “Parallel Power Extend Converter
Installation – Bottom Row” starting on page 33.
Procedure
[ ] 1. If the power extend converter is to be installed for a newly connected load, connect the load and
load return cables for the position to be occupied by the power extend converter. At the same time,
connect the power extend converter return wire faston tab (P/N 565990) provided with the power
extend converter to the cabinet’s return busbar (use the same location as the return lead to the
load). See
Figure 18 . Torque hardware as indicated in Figure 18 .
[ ] 2. If the power extend converter is to replace an existing circuit breaker in the distribution panel,
remove the circuit breaker and verify the load and return cables for the position to be occupied by
the power extend converter are wired correctly. At the same time, connect the power extend
converter return wire faston tab (P/N 565990) provided with the power extend converter to the
cabinet’s return busbar (use the same location as the return lead to the load). See
Figure 18 .
Torque hardware as indicated in Figure 18 .
[ ] 3. Connect the return wire (P/N 564330) and return wire jumper (P/N 565752) provided with the
power extend converter to the power extend converter return wire faston tab (P/N 565990)
installed on the cabinet’s return busbar in the step above. See
Figure 19 .
[ ] 4. Route the return wire (P/N 564330) down and behind the top distribution row, then connect it to the
power extend converter. See
Figure 19 . Orient the white square on the return wire faston
receptacle’s locking tab as shown in Figure 19 .