Vertiv EDGE-1000IMT, Installer/User Manual

Page: 37 / 68

• Product tab - shows UPS identification information, firmware versions, and information about
the communication card (when the card is installed).
To view the product and battery-age information:
1. At the main menu, select the About icon, and press Enter.
2. Use the arrow buttons to move the cursor left/right and select a tab, then press Enter to
display the information for the selected tab.
3. Use the arrow buttons to move the cursor.
4. Press ESC to return to the tab selection. Press ESC again to return to the main menu.
Product Information
Product Type
UPS model name.
Serial number
UPS serial number.
Time since startup
Elapsed time since start-up of the UPS.
UPS FW version
Version of UPS firmware on the control board.
Communication FW version
Version of communication firmware on the communication board.
LCD module FW version
Version of LCD module firmware on the display panel.
Network
MAC address
Shows the MAC address of the SNMP card. This is only shown when the SNMP card is installed
and setup.
IPv4 address
Shows the IPv4 address of the SNMP card. This is only shown when the SNMP card is installed
and setup.
4.2.8 Maintenance screen
The Maintenance screen offers operation of restore factory default.
To restore factory default:
1. Put the UPS in standby mode.
2. At the main menu, select the Maintenance icon, and press Enter.
3. Use the arrow buttons to move the cursor to Restore factory defaults, then press Enter.
4 Operations
33
Liebert® EDGE Installer/User Guide