Vertiv EDGE-1000IMT, Installer/User Manual

Page: 27 / 68

Low battery time
Sounds an alarm when the selected amount of time remains for the UPS to operate in Battery
mode.
• 2 - 30 minutes (default of 2)
Battery periodic test enable
The UPS can periodically self-test the battery.
• Enable (default)
• Disable
Battery reminder(months)
Sets the length of time after the batteries are replaced to generate an alarm to remind the user
to replace the batteries
• Disable (default)
• 1 - 72 months
Discharge protect time
Sets the maximum discharge time for the UPS. The default setting is the maximum, allowing
the battery to fully discharge. This can be set lower to limit the amount of time the UPS will
provide battery protection after which it will shut down. If the discharge time remaining on the
battery is lower than the setting value, it will have no effect.
• 1 - 4320 minutes (default of 4320)
Max Charge current (2U and 3U VRLA models only)
Sets the maximum charge current for the battery. A higher charge current will charge the
battery more quickly but can shorten battery life. A lower value will lengthen the battery
charge time and can increase battery life. The load is always prioritized and the charge current
will be decreased internally if necessary to support the load.
• 1/2/3 A (default of 3)
Temp compensation
When enabled, the UPS will adjust the charging voltage of the batteries based on temperature
in order to preserve battery life. It will increase the voltage if the UPS is operating in a cold
environment. It will decrease the voltage if the UPS is operating in a warm environment.
• Enable
• Disable (default)
Replace battery
Activates newly-installed battery packs after replacement and reset all battery statistics for
new battery packs.
• Provides a confirmation window with Yes/No options to confirm replacement of batteries.
4 Operations
23
Liebert® EDGE Installer/User Guide