7. Click
Save
.
3.8.1 Local virtual media settings
Local users can also determine the behavior of virtual media from the Local Session screen. In addition to
connecting and disconnecting a virtual media session, you can configure the settings in the following
table.
SETTING
DESCRIPTION
CD ROM
Allows virtual media sessions to the first detected CD-ROM or DVD drive. Enable this checkbox to establish a virtual media CD-ROM or
DVD connection to a target device. Disable to end a virtual media CD-ROM or DVD connection to a target device.
Mass
Storage
Allows virtual media sessions to the first detected mass storage drive. Enable this checkbox to establish a virtual media mass storage
connection to a target device. Disable to end a virtual media mass storage connection to a target device.
Reserved
Ensures that a virtual media connection can only be accessed with your username and that no other user can create a KVM connection
to that target device.
Table 3.5 Local Virtual Media Session Settings
To configure local virtual media settings:
1.
From the side navigation bar, select
Local Session
.
2. Select to enable or deselect to disable any of the Virtual Media Session options.
3.9 Modem Settings
From the Appliance Modem Settings screen, you can configure several modem settings, as well as view
the following modem settings: Local Address, Remote Address, Subnet Mask and Gateway.
For information on connecting your switch to a modem, see
Connecting the Switch Hardware
on page 7.
To configure modem settings:
1.
From the side navigation bar, select
Unit View - Appliance - Appliance Settings - Ports - Modem
to open the Appliance Modem Settings screen.
2. Either enable or disable the
Modem sessions can preempt digital sessions
checkbox.
3. Select an Authentication Timeout time from 30 to 300 seconds, and an Inactivity Timeout time
from 1 to 60 minutes.
4. Select
Save
.
3.10 Scan Mode
NOTE: Scan mode is only available when using the local UI.
In Scan mode, the switch automatically scans from port to port (target device to target device). You can
scan multiple target devices, specifying which devices to scan. The scanning order is determined by
placement of the target device in the list. You can also configure the amount of time before the scan
moves to the next target device in the sequence.
NOTE: The Scan button is disabled if you are connected remotely or via modem.
Vertiv
™ | Vertiv™ Avocent® MergePoint Unity™ Switch for Dell® Installer/User Guide |
26
