Vertiv™ NetSure™ IPE Series -48 VDC Outdoor Rectifier Installation and User Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
19
2
Installation
2.1
General
WARNING!
Rectifier warranty will be VOID if any perimeter screw is tampered with. DO NOT loosen or remove any
perimeter screw. Removal of outer perimeter screws is a safety hazard.
The rectifier can be pole mounted or secured to a suitable wall.
If the access panel is opened during installation, ensure the access panel is securely closed and the screws are torqued to 2.5 Nm.
2.2
Tools Required for Installation
Refer to Table 2.1 for a list of tools required for installation.
Table 2.1 Tools Required for Installation
Tool
Specification
Tool
Specification
Combination wrench (hatch,
club)
Wrench set (10#, 13#, 16#, 18#, 21#)
Torque wrench
As required
Electrician diagonal pliers
150 mm
Insulated screwdriver set
Cross screwdriver: #1, #2
Slotted screwdriver: 3 mm, 5 mm
Electrician sharp nose pliers
150 mm
Non-contact voltage tester
/
Tape measure
5 m
Wire stripper
Max. 16mm2
Level
Normal type
Crimping tools
Max. 16mm2
(Both ferrule and lug crimping tools)
Ladder
As required
Digital multimeter
Three-and-a-half-bit digital display
Lifting equipment
As required
Impact electric drill
As required
Lifting sling
As required
ESD wrist strap
/
Cable gland wrench
As required
