Door Setup
HD-98 Door Operator with OST
16
Vertical Express
Door Card Configuration
(continued)
7. For jobs with rear doors:
• The rear door card must be addressed as a rear door card; Remove the J1 jumper
from the rear door card.
• Repeat the sections “Limit Setting and Direction Check” on page 14 and “Door Card
Configuration” on page 15 for the rear door subsystem.
Figure 7 - Door Configuration Jumpers
Door Setup
1. Verify that the hoistway setup has been completed.
2. Place the car at floor level on Automatic Operation.
3. Activate the doors to setup automatically.
a. Use the OST and set adjustment D26 = 0 to deactivate the door disconnect.
b. Set adjustment E56 = 0.
• Display the E56 value in the OST Adjustment menu.
• Press the UP key on the OST. The screen displays "SCAN W____", (with the existing
E56 value after the W).
• Press the Enter key on the OST. The screen displays "E56 *0".
• To accept the change, press the Enter key again.
• To save E56 as zero, press the Enter key a third time.
• Press the Enter key a fourth time. The doors should automatically scan the opening
for the new value.
Note:
The doors will not scan with a value other than zero (0) in E56.
4. View E56 to verify that a value was learned.
5. Use the OST to issue the WRT Command.
Address Jumper Detail
Reset Button
Door Type
Jumpers
J1
J2
J3
J4
RH Front
ON ON OFF Not Used
RH Rear
OFF ON OFF Not Used
LH & CO Front ON OFF OFF Not Used
LH & CO Rear OFF OFF OFF Not Used
