Vertex Standard VX-1210, Service Manual

Page: 14 / 76

14
DSV-1200 I
NSTALLATION
M
ANUAL
Installation Manual Reprint
Installation
r
Turn the transceiver off, remove the Battery Pack from the
transceiver.
r
Disconnect the Microphone from the
MIC
Jack.
r
Remove the five screws affixing the Rear Panel, and remove
the Rear Panel.
r
Remove the two screws which located on the MIC Jack on
the left side of the transceiver.
r
Slide the transceiver cover toward the rear to remove it.
r
Remove the two screws affixing the dummy cover on the rear
chassis, and remove the dummy cover.
r
Mount the
DSV-1200
to the rear chassis using the supplied
two hex screws.
r
Connect the 3-pin connector from the
DSV-1200
to the
J1015 on the MAIN UNIT, and connect the 7-pin connector
from the
DSV-1200
to the
J2012
on the CNTL UNIT.
r
Replace the transceiver cover, ensuring no wires are pinched,
then replace the two screws.
r
Replace the rear panel and its five screws.
r
Installation is now complete.
DSV-1200 Jack Pinout
(
Viewed from Rear Panel
)
Operation
CW Operation
r
Program the operating frequency and CW delay time which
you wish to operating on CW mode via the CE36 Channel
Editor.
r
Connect the CW key to the pin 3 (Signal) and pin 6 (GND) of
the
DSV-1200 (D-SUB 9-pin) Jack on the rear panel.
DATA (AFSK) Operation
r
Program the operating frequency which you wish to operat-
ing on DATA mode via the CE42 Channel Editor.
r
Connect the AFSK modem to the follwing pins of the
DSV-
1200 (D-SUB 9-pin) Jack on the rear panel.
Pin 4: PTT
Pin 6: GND
Pin 8: DATA IN (50 ~ 100 mV @ 10 k
W
)
Pin 9: DATA OUT (approx. 200 mV @ 1 k
W
)
TOP View
PA UNIT
MAIN UNIT
DSV-1200
J
1015
J
2
0
1
2
(
C
O
N
T
L
U
N
IT
)
à  Á À
È Ç Æ Å
Ä