VX-110 O
PERATING
M
ANUAL
22
Scanning
M
EMORY
S
CANNING
Memory scanning is similarly easy to initiate:
Set the radio to the Memory mode by pressing the [
M/V
(
SET
)] key, if necessary.
Press and hold in the [
s
] / [
t
] key for 1/2 second to initiate scanning.
As with VFO scanning, the scanner will halt on any signal encountered that is strong
enough to open the squelch; it will then resume scanning according to the Scan-Re-
sume mode set previously.
To cancel scanning, press the
PTT
, or [
M/V
(
SET
)] key.
H
OW
TO
S
KIP
(O
MIT
)
A
C
HANNEL
D
URING
M
EMORY
S
CAN
O
PERATION
When you have some very active channels stored in memories, you may wish to skip them
when scanning, but still have them available for manual selection.
Such channels may be “Skipped” during scanning, if you like:
Set the radio to the Memory Mode by pressing the [
M/V
(
SET
)] key, if necessary.
Rotate the
DIAL
to select the Memory Channel to be skipped during scanning.
Press the [
F
] key momentarily (not for 1/2 second), then press the [
M/V
(
SET
)] key
(momentarily). A small “
SKIP
” will appear to the LCD. indicating it is to be ignored
during scanning.
To re-institute the channel into the scanning loop, repeat the above three steps (the “Skipped”
channel will, of course, still be accessible via manual channel selection methods using the
DIAL
in the MR mode).
A
UTOMATIC
L
AMP
I
LLUMINATION
ON
S
CAN
S
TOP
The
VX-110
will automatically illuminate the LCD Lamp whenever the scanner stops on a
signal (the default condition for this feature is “ON”).
The procedure for disabling the Scan Lamp is:
Press the [
F
] key, then press the [
M/V
(
SET
)] key, to enter the Set mode.
Rotate the
DIAL
to select Menu #7 (“
SCN LMP
”).
Press the [
F
] key to enable changing of this Menu item.
Rotate the
DIAL
to set this Menu item to OFF.
When you have made your selection, press the
PTT
key to save the new setting and exit
to normal operation.
