Vertex Standard GX1256S, Alignment Manual

Page: 3 / 7

FCC ID: K6630053X30
IC ID: 511B-30053X30
Alignment
3/7
Vertex Standard Co,. Ltd.
(a) Expansion channels “EXP01 - EXP07” will be set as follows:
DISPLAY RX Frequency TX Frequency SCAN Channel
EXP01 156.050 MHz 156.050 MHz X
EXP02 157.425 MHz 157.425 MHz X
EXP03 163.275 MHz 158.675 MHz X
EXP04 155.050 MHz 155.050 MHz O
EXP05 162.025 MHz 162.025 MHz X
EXP06 163.575 MHz 158.975 MHz X
EXP07 159.050 MHz 159.050 MHz X
WX10 163.275 MHz --- O
(B) In CH70, every time you are in transmit mode, (every time you press PTT), the
following test tone can be outputted:
1st transmission: 1300 Hz
2nd transmission: 2100 Hz
3rd transmission: No modulation
4th transmission: Synthetic tone of 1300 Hz and 2100 Hz
5th transmission: Return to 1st transmission
(C) Scan the channels between WX10 and EXP04 in the SCAN mode.
Starting Test Mode
Confirm that PWR/VOL switch is off, and short the TEST points. Turn on the PWR/VOL
switch while press and holding the DIST and DW keys.
Confirmation of VCO
-- Confirmation --
ˆ Connect the DC voltmeter to the test point (LOCK TP).
ˆ Use the UP/DOWN key to set the channel to EXP04 , confirm that voltage on the test
point is over 1.0 V in the receive and transmit mode.
ˆ
Use the UP/DOWN key to set the channel to EXP05 , confirm that voltage on the test
point is below 5.0 V in the transmit mode.
ˆ
Use the UP/DOWN key to set the channel to EXP06 , confirm that voltage on the test
point is below 5.0 V in the receive mode.
Adjustment and Confirmation of Transmit Power
Adjust power at high and low in the transmit mode, and confirm power in the specified
bandwidth.
-- Adjustment --
ˆ Connect the wattmeter and 50-ohm dummy load to the antenna jack.