Page
14
of
17
FREQUENT PROBLEMS
TROUBLE
CAUSE
SOLUTION
The fire turns on
wrong or no I know
maintains
Wood green or too much wet
Use dry wood and what is been stored in a closed place and ventilated.
The logs They are too fat
For the switched on, use paper, ignition pads and little wood dry.
For the maintenance from fire, use logs matches.
Wood from bad quality
Use wood dry of oak, ash, maple, birch, elm, beech, etc. They have
high calorific value and produce good embers.
primary air insufficient
To open completely register from admission from air primary.
Shot is insufficient
check what the conduit no East blocked, make a chimney sweep Yes
is necessary.
Insufficient tube length. Expand tube.
The fire I know
accelerate
Excess from air primary
Close partial or completely the registration admission from air primary
.
Shot is excessive
check what the clapper from threw no I know is left open.
Install a moderator from threw.
Smoke emission to
turn on or during the
combustion
the conduit from smoke is cold Reheat the conduit burning a Torch from paper inside the home.
The room is on depression
Inside from a bedroom equipped with a MCV (mechanical ventilation),
ajar a window what from toward the outside.
Shot is insufficient
check what the conduit no East blocked, make a chimney sweep Yes
is necessary.
Insufficient tube length. Expand tube.
Wind enters inside the conduit
Install a windproof finish .
check that the length of the duct exceeds the ridge of the roof.
Heating insufficient
Wood from bad quality
Use wood dry of oak, ash, maple, birch, elm, beech, etc. They have
high calorific value and produce good embers.
Bad mix from air hot from
convection.
Check the circuit from convection (rack from entry, from diffusion,
conduit d air).
The glass is dirty
quickly
Shot is insufficient.
check what the conduit no East blocked, make a chimney sweep Yes
is necessary.
Insufficient tube length. Expand tube.
Absence from admission from
air the Exterior.
Install a rack from admission from air (20x20 cm by example) near
from the chimney.
Wood green or too much wet.
Use dry wood and what is been stored in a closed place and ventilated.
Wear Quick from the
elements from steel.
Ventilation insufficient the
apparatus.
check the circulation from air, recovering the heat the apparatus
increasing the openings and the grids from ventilation.
check what the system from aeration no East blocked by the grids
closed (use grids no adjustable).
Empty every day the ashtray.
The meeting from the
door I know takes off
Utilization abusive of liquid
abrasive when I know clean
the crystal.
Use cleaning fluids from way what no I know strain below of the glass
or clean up with a product foam.
Condensation inside
the apparatus
Combustion from wood wet to
fire slow .
Use dry wood and what is been stored in a closed place and ventilated
(careful, the wood newly cut contains more or less 5L from Water for
10 kg).
Absence from Exit
from air hot of the
insert
Lack from electricity. Fan
defective.
check what is stream. Always there are what connect the wire to a
Plug integrated.
No I know can do fire without stream or well use other feeding. Change
the element defective.
