EPM-15 Reference Manual
8
Configuration and Setup
Initial Configuration
The following components are recommended for a typical development system.
EPM-15 Computer
ATX Power Supply
SVGA Video Monitor
Standard I/O Utility Cable (CBR-5010)
USB Keyboard
USB Floppy Disk Drive
IDE Hard Drive (optional)
IDE CD ROM Drive (optional)
The following VersaLogic cables are recommended.
CBR-1201 – Video adapter cable
CBR-5010 – Utility I/O cable (CBR-5009A) and breakout board (CBR-5010B)
CBR-4406 – IDE data cable
CBR-4405 – IDE adapter board, if you are using drives with 40-pin connectors
CBR-1008 – Power adapter cable
You will also need a Windows (or other OS) installation CD.
Basic Setup
The following steps outline the procedure for setting up a typical development system. The EPM-
15 should be handled at an ESD workstation or while wearing a grounded antistatic wrist strap.
Before you begin, unpack the EPM-15 and accessories. Verify that you received all the items you
ordered. Inspect the system visually for any damaged that may have occurred in shipping.
Contact [email protected] immediately if any items are damaged or missing.
Gather all the peripheral devices you plan to attach to the EPM-15 and their interface and power
cables.
It is recommended that you attach standoffs to the board (see Hardware Assembly) to stabilize the
board and make it easier to work with.
Figure 3 shows a typical start-up configuration (using RoHS compatible cables).
2
2
