Compatibility Issues
• Link flap issues may occur if the remote device is an older Cisco Nexus 3064 switch (2012).
• After you reboot CSG700 appliances, the link error "DCX-NO Ack in 100 PDUs" may occur on Cisco Nexus
switches. As a workaround, issue the
shutdown
command followed by a
no shutdown
on the Cisco switch
interface that is used for link detection.
• BASE-T SFP modules for Denverton-based boards are not supported.
Installation Guidelines
This article provides general safety standards and warnings relating to installing or connecting a CSG700 series
appliance.
General Safety Guidelines
Caution: Before installing or removing a CSG700 series appliance, ensure that the appliance chassis is electrically
connected to ground. When you are installing or removing an appliance, ensure that you wear an ESD grounding wrist
strap. To put the ESD grounding strap on properly, attach it to an ESD point and then place the other end of the strap
around your bare wrist, making good skin contact. Failure to use an ESD grounding strap could damage the appliance.
• Install the CSG700 series appliance in compliance with the following local, national, and international electrical
codes:
• United States—National Fire Protection Association (NFPA 70), United States National Electrical Code.
• Other countries—International Electromechanical Commission (IEC) 60364, Part 1 through Part 7.
• Evaluated to the TN power system.
• Canada—Canadian Electrical Code, Part 1, CSA C22.1.
• Locate the emergency power-off switch in the installation area. In case of an electrical accident, turn off the power
quickly.
• Disconnect power to the appliance before installing or removing it.
• Disconnect power from the circuit that is being used for the appliance.
• If hazardous conditions exist, do not work alone.
• If you are working under conditions that might be hazardous to the eyes, wear safety glasses or goggles.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
https://docs.versa-networks.com/Hardware/Cloud_Services_Gateway_700_Series/Complete_CSG700_Series_Hardware_Gui…
Updated: Tue, 18 Oct 2022 06:10:27 GMT
Copyright © 2021, Versa Networks, Inc.
22
