1 (800) 465-1660
American Manufacturing
Lifetime Warranty
Protected by US Patent No. 10,485,336 & 10,849,424
VERSA DESK
®
Assembly Instructions
VERSA DESK
®
Press the DOWN button until the desk reaches the lowest position.
Measure the height from the floor to the top surface of the desktop.
If the displayed height does not match your measurement, follow these steps:
Press the DOWN button until display flashes “ASR”.
Press the “S” button until the numeric display begins flashing.
Use the UP/DOWN buttons to set the value so that it matches your measured height.
Once display changes back to “ASR”, press DOWN button until the desktop lowers and rises
slightly.
The desk is designed to go to its minimum and maximum height limits, allowing for the widest
possible range. If you prefer a narrower range, follow these steps to adjust the upper and lower
limits:
To Set a new maximum desk height:
Press the UP or DOWN button to move the desk to the desired maximum height.
Press the “S” button once, and then the UP button once. The Display will flash “S-”
Press and hold the “S” button until the Display shows “999”, and then changes to numeric value of
new upper limit.
To Set a new minimum desk height:
Press the UP or DOWN button to move the desk to the desired minimum height.
Press the “S” button once, and then the DOWN button once. The Display will flash “S-”
Press and hold the “S” button until the Display shows “000” and then changes to numeric value of
new lower limit.
Removing adjusted maximum and minimum heights:
Press and hold the “S” button until the display flashes “S-”.
Within 5 seconds, press the “S” button again and hold for 2 seconds. The display will change to
“555” and return to the current numeric height setting. Limits are now removed.
Note: If memory settings were previously set outside of the new minimum and maximum height
settings, they will default to the new minimum and maximum settings. To set new minimum and
maximum height settings outside of the current settings, you will need to first remove the current
minimum and maximum settings.
Calibrating the Height
Technical Specifications
Setting the Upper/Lower Limits
Height Range
Base Width
Travel Speed
Weight Capacity
Duty Cycle
23.5” - 49” (excluding desktop)
42” min. - 74” max
1.5” per second (no load)
1000N
10%. Max. 2 mins on, 18 mins off
Soft start / stop
Adjustable Leveling Studs
4 Memory presets
