versa climber CL-108H, Operational Manual

Page: 42 / 54

13. Adjust screw (24) at the bottom of the angle
brace (16) up or down until blase plate lays flat
on the surface on which it is placed. Then rotate
the two levelers (54) located on the base plate to
level the machine right to left. If the machine is
placed on a deep pile carpet, it may be neces-
sary to readjust the two leveling knobs after two
or three days of use.
14. Be sure that all assembly steps have been
accurately and thoroughly completed. Be extra
careful to ensure that all the nuts are tight and
that the foot pedals and hand rails are securely in
place.
Note: There are three handle and foot pedal loca-
tions. For adults, screw the foot pedals into the
lower holes and the hand grips into the holes that
locate the hand grips at about shoulder height.
The foot pedal can also be raised to a higher hole
locations for shorter adults or children. Be sure to
tighten the foot pedals securely with a wrench
every time that they are installed.
15. Insert the display control connector on end of
coil cord into the connector on the top of the post.
The male connector on the coiled cord has a
guide rib that must line up with the female con-
nector on the machine prior to insertion.
Page 37
Place the display console (Module) on
the machine in contact with the velcro
strips.
Rotate leveling knob up or down until
blase plate lays flat on the surface on
which it is placed.
While standing on the pedals in the
level position, the console (Module)
should be at about eye level.