9
3-Wire Flat Power Cord Installation
(See Figures 2.1 and 2.2)
1. Remove the
Terminal Block Access Plate
on the back of the
range by unscrewing the 4 fixing
Screws
.
2. Insert the
Flat Power Cord
through the
Bracket
; then
tighten the
Flat Power Cord
by using the
Strain Relief
.
Allow enough slack to easily attach the cord terminals to the
Terminal Block
.
3. Remove the 3 wire terminal nuts and washers from the
Terminal Block
.
4. Plug the terminal holes of
Flat Power Cord
. The
Neutral or
Ground Wire
of the
Flat Power Cord
must be connected to
the neutral terminal located in the center of
Terminal Block
.
The
Power Wires
must be connected to the outside termi-
nals.
5. Plug washers and tighten nuts securely.
Do not remove
Ground strap
.
6. Assemble the
Terminal Block Access Plate
.
Terminal Block
Access Plate
Screws
Neutral Wire
Power Wires
Bracket
Flat
Power Cord
Terminal Block
Ground strap
Strain Relief
Fig. 2.1
Fig. 2.2
