- 8 -
FI 70 30P 09-2010 EUROCHEF 9880022500.doc
ABNORMAL OPERATION
Any of the following are considered to be abnormal operation and may
require servicing:
- Burner flame with yellow tips.
- Difficult burner ignition.
- Burners fail to remain lighted.
- Burner will flame out.
- Difficult on turning gas valves.
NOTES:
Control regularly the correct functioning of oven gas thermostat and selector
switch.
In case of abnormal functioning of these devices, you must immediately
call a qualified technical assistance service.
OVEN DOOR
TO REMOVE OVEN DOOR
1) Fully open the oven door.
2) Insert a metal Locking Pin (B) in the Locking Hole (A) on each of the
hinges, see figure 07.
3) Grasp the door by the sides toward the back. Raise the front of the door a
few inches and make sure the Locking Pin (B) is locked by the door hinge.
This will prevent the hinge from snapping closed when the door is
removed. (there will be some spring resistance to overcome because of
the hinge being locked). When the front of the door is high enough and
hinges are locked, you will be able to lift the hinges to clear the slots
4) Pull the hinges out of the slots in the oven front frame.
TO REPLACE THE OVEN DOOR
1) Grasp the sides of the door at the centre and insert the ends of the hinges
and fix hinge slots in the oven front frame.
2) With the door open all the way, pull-out the two Locking Pins (B) from the
hinge Locking Holes(A).
3) Raise the oven door and make sure that it fits evenly with the front sides.
WARNING:
Never take out the Locking Pins while the door is off. Do not
close the hinges without the weight of the door, the powerful springs will snap
the hinges closed with great force.
