11
3
BURNERS
•
These parts can be removed and cleaned with appropriate products.
These parts must be cleaned using a sponge and soapy water or other suitable non-
abrasive products. Dry with a soft cloth.
Warning! Not dishwasher safe.
•
After cleaning, the burners and their flame distributors must be well dried and correctly
replaced.
•
It is very important to check that the burner flame distributor and the cap have been
correctly positioned. Failure to do so can cause serious problems.
•
Check that the probe “
T
” (figs. 3.1, 3.3) next to each burner is always clean to ensure
correct operation of the safety valves.
•
Check that the electrode “
S
” (figs. 3.1, 3.3) next to each burner is always clean to
ensure trouble-free sparking.
•
Both the probe and ignition plug (electrode) must be very carefully cleaned.
•
Note: To avoid damage to the electric ignition do not use it when the burners are
not in place.
CORRECT REPLACEMENT OF THE AUXILIARY, SEMI-RAPID
AND RAPID BURNERS
It is very important to check that the burner flame spreader “
F
” and the cap “
C
” have been
correctly positioned (see figs. 3.1 and 3.2 ).
Failure to do so can cause serious problems.
CORRECT REPLACEMENT OF THE TRIPLE-RING BURNER
The burner must be correctly positioned; failure to do so can cause serious problems.
Fit the flame spreader to the housing as shown by the arrows (see figs. 3.3, 3.5).
The burner correctly positioned must not rotate (fig. 3.4).
Then position the cap “
A
” and the ring “
B
” (figs. 3.4, 3.5).
S
F
C
T
A
B
T
S
Fig. 3.1
Fig. 3.2
Fig. 3.3
Fig. 3.4
Fig. 3.5
Note: Continuous use may cause a change in the glaze around the burners
and grids, corresponding to the areas exposed to the heat. This is a natural
phenomenon and does not prevent the parts from working properly.
