Page 1717 of
18
After “OK” button is pressed, Figure 4.5 appears. If the Hyper Terminal connects with the converter
successfully, the time clock at the “left lower” corner “Connected hh:mm:ss” will start counting.
Figure 4.5
Hyper Terminal for COM Port
Initiate another Hyper Terminal as a COM Port Terminal (in Figure 4.3, select COM 1 or other COM port
instead of “TCP/IP (Winsock)”). Set the COM port Properties to be the same as those set for the Serial Port of
the converter.
Figure 4.6
Data Transmission
When all steps described above are finished, type any characters on the COM Port Terminal and check if the
typed characters are also displayed on the TCP/IP Winsock Terminal. Alternatively, check if the characters
typed on the TCP/IP Winsock Terminal are also displayed on the COM Port Terminal. If yes, then all settings
are correct and the converter can operate properly.
