18
20304166
VCFDVI31 Gas Fireplace Insert
INstAllAtION
INtAKe/exhAust MANIFOlD ReMOVAl
AND VeNt INstAllAtION
The intake/exhaust manifold is shipped attached to insert.
It may be removed to allow tight installation.
1. Unfasten the two (2) machine screws on the face of the
unit and release the plate assembly by sliding the plate
back.
2. Attach the exhaust and the intake flex pipes to the collar
on the plates with a hose clamp (not provided) or other
approved methods (check local codes).
The unit is shipped from the factory as a natural gas unit
with the baffle installed. The baffle should be sufficient for
venting up to 20 feet (6 m) off the top of the unit. An extra
baffle plate is shipped with the unit for installations of 20
feet and above.
Remove four (4) screws holding baffle plate. Add extra
baffle pate and reinstall screws. Align slots in baffle plates
so the slots are closed. Retighten screws.
NOte:
For propane (LP) units the baffle assembly is com-
pletely removed for venting under 20 ft. (6 m). For venting
20 ft. and above, the baffle assembly is to be used with
only one (1) baffle plate installed.
Figure 26
FP1961
baffle adjustment
9/08
Loosen Four (4) Screws to Adjust
Bottom View
Closed position
Bottom View
Open position
FP1961
Figure 26 -
Baffle Assembly and Adjustment
3. Slide plate assembly back in place under locating
tabs.
4. While sliding unit in place, if necessary the glass latch/
shutoff tool can be used to help place the plate assem-
bly. Using the small end of the tool, insert it in the square
notch in top front of firebox. Hook the plate assembly
with tool and pull forward into place while sliding firebox
to the rear.
Figure 25
5. Reinstall and tighten machine screws.
FP2977
latch tool plate assy
Plate
Assembly
Latch Tool
FP2977
Figure 25
FP2979
intake exhaust
Figure 24
Machine
Screws
Intake Collar
Exhaust/Intake
Slide Plate
Assembly
FP2979
Exhaust Collar
