5
3311857
This Damper Stop is designed to work on all CFM
Corporation BR, BC, SR, SC, TF and TL series
fireplaces. For all other fireplaces, refer to Page 6.
When installing a decorative gas appliance in a
fireplace, some local codes require this Damper
Stop to be used so the Damper will not close com-
pletely. To install the Damper Stop:
The Damper Locking Bracket is already installed
on all BR, BC, SR, SC, TF and TL fireplaces. Lo-
cate the Damper Locking Bracket on the left side
of the fireplace’s Combustion Dome. (Fig. 1)
With the Damper open, align the two slots on
either side of the cut-out on the Damper Stop with
the two small holes on the angled portion of the
Damper Locking Bracket. Attach the Damper Stop
with the Screws provided, as shown in Figure 2.
NOTE:
Some of the early fireplace units may not
have the holes in the end of the Damper Lock-
ing Bracket. If this is the case, use the Damper
Stop as a template to drill two (2) 1/8” holes in the
Damper Locking Bracket to mount the Damper
Stop.
NOTE:
Your gas log set is assembled at the factory to be installed in a fireplace plumbed with the gas on
the right side (facing). If your fireplace is plumbed with the gas on the left side, you will need to run a flex-
ible connector (or as per local codes) along the back wall of the fireplace to bring your gas line to the right
hand side. You can then place the set in front of the flexible connector.
Gas Plumbed on Left Hand Side of Fireplace
8” adjustable crescent wrench ; Pipe thread sealant compound or teflon tape ; 12” pipe wrench or channel
lock pliers.
Tools Required
Damper Stop Installation:
For Use with BR, BC, SR, SC, TF and TL Series CFM Corporation Fireplaces
DP100
Damper locking bracket
3/19/99 djt
Figure 1
Damper
Plate
Damper Locking Bracket
DP100
DP101
Damper stop
3/19/99 djt
Figure 2
Damper Locking Bracket
Damper Stop Screw
Damper Stop
DP101
Summary of Contents for SA18SHKRN
Page 18: ......
