27
Radiance
®
Direct Vent Gas Heater
20306759
LG488
rear log
6/07
Rear Log
LG488
Figure 48
CAUTION:
Before installation, inspect ember
bed burner for damage.
Do not use
ember
bed if damaged or cracked.
NOTE:
Small,
shallow surface cracks are acceptable.
1. Remove the logs from their packaging and
inspect each piece for damage.
DO NOT
INSTALL DAMAGED LOGS.
2. Install the rear log by placing it on the
ember bed toward the back of the firebox.
(Fig. 48) The log should touch the back
wall of the firebox. When the log is in place,
the two (2) notches on the bottom of the log
rest on the two (2) ribs on the back side of
the ember bed. (Fig. 49)
LG487
ember bed
6/07
Ribs for Rear Log
Ember Bed
Rib Flat Spot for
Front Left Log
Rib and Flat Spot
for Front Right Log
LG487
Figure 49
LG489
front logs
6/07
Figure 50
Front Left Log
Front Right Log
LG489
3. Install the front left and right logs
(Fig. 50) by placing them on the
ribs shown in Figure 49. Make
sure the logs line up with the flat
spots on the ember bed intended
for location purposes. (Fig. 49)
4. Install the left cross log by engag-
ing the hole on the bottom with the
pin on the left side of the rear log.
Set front side of cross log on notch
in ember bed. (Fig. 51)
5. Install the right cross log by engag-
ing the hole on the bottom with the
pin on the right side of the rear log.
Set front edge of cross log on em-
ber bed as shown in Figure 51.