35
20306747
DVM Series Direct Vent Gas Fireplace
FINAL INSTALLATION
GLASS FRAME REMOVAL
NOTE:
If the safety barrier is in place, you must first remove
it before you remove the glass frame. To remove the barrier,
simply lift up and pull out until the tabs are clear of their
corresponding slots on the firebox. Then proceed to remove
the glass frame by following the steps below.
1. Remove louver assembly from the top.
2. Release three (3) clamps on bottom of fireplace.
3. Tilt glass frame out and lift glass frame up until it clears
hook on top of fireplace.
4. Set glass frame aside.
Figure 55
Figure 55 -
Remove Glass Frame
Glass
Frame
Safety
Screen
Barrier
CAUTION
Each clamp has a quick spring force. When
reinstalling clamps, keep fingers clear.
BRICK INSTALLATION
500DVM (1-Piece)
1. Install floor brick before installing logs or rock wool.
2. Install the rear brick panel by sliding it over the existing
bracket fastened to the rear of the firebox.
3. Remove the existing screws fastened to the sides of the
firebox toward the tops.
4. Slide the right panel into place and secure the panel
using one of the brackets provided with the kit and one
of the screws removed earlier.
5. Repeat step 3 for the left panel.
DANGER
HOT GLASS
WILL
CAUSE BURNS
.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud
peut
causer des brûlures.
Laissez refroidir le panneau
vitr
é
avant d’y toucher.
Ne laisser jamais
les enfants
toucher le panneau vitr
é
.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.
Une barrière visant à réduire le risque de brûlure
par le hublot chaude est fournie avec cet
appareil et doit être installé.
DANGER
