Ceres SE
2021-08
Using your scooter
14
EN
NL
When the operating console displays the warning code “Drive inhibit” after charging, make
sure that the battery charger is disconnected. This safety measure prevents driving with the
charger still connected to the supply grid.
3.8 Thermal fuses
To protect the motor against overload, your scooter has a thermal
safety mechanism on the rear. The thermal fuse will automatically cut
off the motor to prevent overheating and thus rapid wear and tear or
breakdowns. You can access the thermal safety device through a gap
in the back of the synthetic cover.
The thermal safety device can be activated if you go up or down
slopes that exceed the maximum specified gradient. Nominal loads
that exceed the permitted maximum could also cause the device to
jump out. Likewise, if you keep on driving with the engine brake on, it could result in overload.
The maximum values not to exceed are indicated in §6.
To be able to use the scooter again, remove the overload and wait until the motor has cooled
down. Then gently press the thermal safety mechanism back in. Your scooter is now ready for
use again.
3.9 Anti-tipping
An anti-tipping (1) is fixed to the frame of the scooter on
the rear side. It is not possible to remove these. The anti-
tipping is there for your safety. It prevents the scooter from
tipping over backward when you drive over small
obstacles that do NOT exceed the maximum height as
specified in §6.
1. Key
2. Socket battery charger
2
1
1
