Vermeiren 10.50.04.1246, User Manual

Page: 9 / 72

Eco-Plus
2020-09
5
EN
NL
1. Pull seat frame (23) a bit up to make room.
2. Mount the storage bag with the six snap
fasteners (20) and two Velcro straps (21).
Make sure that the two protection sleeves
(22) stay uncovered.
3. Push seat and seat frame down.
Figure 7: Storage bag assembly
4.4 Disassembly
Risk of damage to
the brakes
Pay attention to the position of the brake
cables and don’t pull the handgrips too
high to prevent damage to the brake cable.
The disassembly of the rollator is conducted
in reverse order to the assembly described in
the previous section:
1. Storage bag: Open snap fasteners and
Velcro straps to remove the bag.
2. Velcro strap for walking stick: Remove.
3. Cable clamp (2x): Pull it from the frame
tube carefully.
4. Handgrip with brake lever (2x): Remove
knob (12) and pull the handgrip out of the
base frame.
5. Base frame: Turn and place it with the front
frame on a surface.
6. Wheel support with rear wheel (2x): Press
and hold silvery push button (16) and pull
the wheel support out of the base frame.
7. Base frame: Turn and place it with the rear
frame on the surface.
8.
Front-wheel frame (8): Remove on each
side, fastener pin (7) and pull the tubes out
of the base frame.
5 Using your rollator
5.1 Unfolding / folding
Risk of entrapment
Keep fingers, buckle and clothes away
from the folding mechanism and frame
cross.
Risk of falling
Check that the rollator is completely open
and that the frame is locked.
5.1.1 Unfolding rollator
1. Push both brake levers down to parking
position, see §5.2.
2. Place the rollator with the rear wheels on
the ground while holding the handgrips.
3. Push seat and seat frame (23) down to
horizontal position.
4. Turn the backrest down, if it is up.
5. Adjust the rollator to the desired height
(see §4.2).
Figure 8: Unfolding rollator
5.1.2 Folding rollator
1. Stand behind the rollator.
2. Push both brake levers down to parking
position, see §5.2.
3. Turn the seat upward.
4. Empty the storage bag.
5. Pull the seat frame (23) upward, to close
the frame a bit.
6. Close the frame completely by pushing
front and rear tubes together.
7. If necessary, turn the backrest upwards.
CAUTION
CAUTION
CAUTION
21
23
22
20
23