Vermeer S650TX, Operator'S Manual, Page: 58 / 88

40-10 Preparation S650TX Mini Skid Steer
Attachment - Install
Step 1: Position attachment on a level
surface with sufficient area behind
it to accommodate the machine.
Step 2: Ensure pins are rotated so that
tops of pins face outward as shown
(1) .
Step 3: Start machine, and lower lift arm.
Tilt loader mounting plate forward
slightly.
Step 4: Drive machine FORWARD, aligning loader mounting plate with attachment.
Step 5: Once top edge of mounting plate enters under lip of attachment mount as shown (2) , raise lift arm while tilting
mounting plate back to securely engage attachment.
Step 6: Raise attachment sufficiently to clear the ground. Tilt attachment plate back fully.
Step 7: Ensure Ground Drive and Lift/Tilt Controls are in NEUTRAL, and shut off machine.
Step 8: Rotate pins 180° so that pins engage and extend through bottom of attachment
mount and are visible beneath attachment mount. Tops of pins must face inward
as shown
(3) .
Ensure pin ends extend through and are visible beneath attachment mount.
Step 9: If attachment requires hydraulic power, see “Hydraulics - Attach.” Refer to page
40-13.
1
2
1
3