S450TX Mini Skid Steer
Preparation 40-11
Attachment - Install
Step 1:
Position attachment on a level surface with
sufficient area behind it to accommodate
the machine.
Step 2:
Ensure pins are rotated so that tops of pins
face outward as shown
(1)
.
Step 3:
Start machine, and lower lift arm. Tilt
loader mounting plate forward slightly.
Step 4:
Drive machine FORWARD, aligning loader
mounting plate
with attachment.
Step 5:
Once top edge of mounting plate enters under lip of attachment mount as shown
(2)
, raise lift arm
while tilting mounting plate back to securely engage attachment.
Step 6:
Raise attachment sufficiently to clear the ground. Tilt attachment plate back fully.
Step 7:
Ensure
Ground Drive
and
Lift/Tilt Controls
are in NEUTRAL, and shut off machine and remove key.
Step 8:
Rotate pins 180° so that pins engage and extend through bottom of attachment
mount and are visible beneath attachment mount. Tops of pins must face inward
as shown
(3)
.
NOTICE:
Ensure pin ends extend through and are visible beneath attachment mount.
Step 9:
If attachment requires hydraulic power, see “Hydraulics - Attach.” Refer to
“Hydraulics - Attach,”
1
2
3
Summary of Contents for S450TX
