Z202815-0Q
Page 4 of 4
©2021 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 0621
12345 SW Leveton Drive, Tualatin OR 97062 USA
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
H681x-V Series Installation Guide
These products provide basic insulation to 600 Vac between the sensed conductor and the output leads. For reinforced
applications, the installer must provide appropriate insulation. Reinforced insulation is provided for applications to 300 Vac
between the sensed conductor and the output leads.
Ratings
4. Close and latch the CT, and mount it securely.
RISK OF INJURY OR EQUIPMENT DAMAGE/ RISQUE DE BLESSURE OU DE
DÉTÉRIORATION DE L’ÉQUIPEMENT
• Secure the I-bar to U-bar so that it remains in place. Close the CT with a suitable cable tie. / Fixer la barre
en I à la barre en U de sorte qu’elle reste fermement en place. Fermer le TC à l’aide d’un serre-câble
adapté.
Failure to follow these instructions may result in injury, fire or equipment damage. /
Le non-respect de ces instructions peut entraîner un risque de blessure, d’incendie ou
de détérioration de l’équipement.
WARNING/AVERTISSEMENT
Note: These split-core devices have a detachable I-bar. If the I-bar is removed, re-orient it according to the markings on the core
surface, then re-attach it. In any application where fault currents can exceed 20 times the rated current of the CT, use wire ties
or similar fasteners to secure both sides of the I-bar to the CT housing.
Note: The CTs except UL2808 require a single cable tie to secure the I-bar. Make sure to use the hole provided for cable tie. The
UL2808 100 - 400 A and UL2808 600 - 800 A CTs require a double cable tie. The UL2808 1000 - 2400 A CTs have a push-pin to
secure the I-bar and no cable tie is required.
5. Reconnect power to the panel.
Note: An optional mounting kit is available for these devices (Veris part number AH06).
