Z207188-0A
Page 2 of 4
©2016 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 0516
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
H623-10 Installation Guide
TM
Regulatory
Information
A qualified person is one who has skills and knowledge related to the
construction and operation of this electrical equipment and
installations, and has received safety training to recognize and avoid
the hazards involved.
NEC Article 100
If this product is used in a manner not specified by the manufacturer,
the protection provided by the product may be impaired. No
responsibility is assumed by the manufacturer for any consequences
arising out of the use of this material.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR
ARC FLASH
• Follow safe electrical work practices. See NFPA 70E in the USA, CSA
Z462 in Canada, or applicable local codes.
• Read and understand the instructions before installing the
product. Follow the instructions during installation.
• Installation, wiring, testing or service must be performed only by
qualified persons in accordance with all applicable codes and
regulations.
• Install the product in an appropriate electrical and fire enclosure
per local regulations.
• Do not use the product for life or safety applications.
• Do not install the product in hazardous or classified locations.
• Do not exceed the product’s ratings or maximum limits.
• The product may use multiple voltage/power sources.
• Turn off ALL power supplying equipment before working on or
inside the equipment.
• Use a properly rated voltage sensing device to confirm that all
power is off.
• Do NOT depend on the product for voltage indication.
• Products rated only for basic insulation must be installed on
insulated conductors.
• Current transformer secondaries (current mode) must be shorted
or connected to a burden at all times.
• Remove all wire scraps and tools, replace all doors, covers and
protective devices before powering the equipment.
Failure to follow these instructions will result
in death or serious injury.
DANGER
