10
VPC5000 COUNTER TOP INSTALLATION
INSTRUCTIONS
Your VeriPure® System offers the option of quick counter top installation.
Caution:
Please be aware that your VeriPure® System
CANNOT BE SUBMERGED IN WATER
. Extra care should
be taken when choosing the counter top location for your VeriPure® System so that it will not get wet or
accidentally knocked into a sink or water basin.
Step 1:
Place your VeriPure® System on a counter on the left side of your sink. There are only two possible
orientations for the VeriPure® System to sit on a counter top
(see photos on page 11).
Step 2:
Remove the
3/8”
clip from the 3/8 outlet on the Veripure® System.
Step 3:
Insert the 3/8 tube into the VeriPure® System outlet until fully seated, Replace red
3/8”
locking clip
Step 4:
Insert the
1/4”
stem adapter fitting into the filter cartridge.
Step 5:
Position the handle of the diverter valve in your preferred location and then hand tighten the diverter valve
collar.
Step 6:
Connect power cord to the VeriPure System and plug into wall outlet.
Step 7:
To operate your VeriPure System turn on your faucet,
COLD WATER ONLY
and turn the diverter valve handle.
Your VeriPure System will automatically turn on as water flows through it (verified by green unit on light on LED
readout). Flush the filters for 10 minutes as directed and check for leaks.
Note: See Flushing Instructions Below.
FLUSHING INSTRUCTIONS
•
TURN ON THE WATER SUPPLY AND
FLUSH NEW CARTIDGES FOR 10 MINUTES
, RUNNING
WATER THROUGH THE SYSTEM
•
NEW FILTER ASSEMBLIES MAY CONTAIN
“
CARBON FINES
”
AND THE WATER MAY BRIEFLY
APPEAR GRAY, BUT WILL QUICKLY DISAPPEAR ONCE FLUSHED.
•
IMPORTANT–
CHECK THAT ALL WATER LINES ARE SECURE AND FIRMLY SEATED WITH NO
EVEIDENCE OF WATER LEAKAGE. IF A LEAK IS DETECTED, SHUT OFF WATER SUPPLY AND
DISCONNECT LINES AND VISUALLY CHECK FOR ANY DEFECTS AT THE END OF LINES. INSERT
LINES BACK IN UNTIL FULLY SEATED AND TURN WATER SUPPLY BACK ON. RECHECK FOR
ANY LEAKS.
