15
S
ERVICE AND
M
AINTENANCE
BEFORE ANY SERVICING IS CARRIED OUT ISOLATE THE APPLIANCE
FROM THE GAS SUPPLY. AFTER REFITTING THE APPLIANCE, CHECK
FOR GAS SOUNDNESS AT ALL GAS JOINTS AND TEST FOR SPILLAGE.
This product uses fuel effect pieces containing Refractory Ceramic Fibre
(RCF). This material contains man-made vitreous silicate fibres. Excessive
exposure to these materials may cause temporary irritation to eyes, skin
and respiratory tract; consequently, it makes sense to take care when
handling these articles to ensure that the release of dust is kept to a
minimum.
To ensure that the release of fibres from these RCF articles is kept to a
minimum, during installation and servicing we recommend that a HEPA
filtered vacuum cleaner is used to remove any dust accumulated in and
around the appliance before and after working on the appliance. We
recommend that any replaced items are not broken up, but are sealed
within heavy duty polythene bags and clearly labelled as RCF waste. RCF
waste is classed as a stable, non-reactive hazardous waste and may be
disposed of at landfill sites licensed to accept such waste. Protective
clothing is not required when handling these articles but we recommend
that the normal hygiene rules are followed of not smoking, eating or
drinking in the work area and that hands are washed before eating or
drinking.
The appliance should be serviced at least once a year by a CORGI
registered engineer. This is the basic procedure.
1
Remove the fascia panel. See section above headed ‘Installing the Fascia Panel’.
2
Unscrew the eight nuts and remove the glass door.
3
The ‘Cotswold Stones’ should be taken off the fire. The centre row should be
carefully lifted off the locating spikes and kept in order so that they can be
returned to their original positions. All the pieces should be shaken to remove
any debris but should only be cleaned if absolutely necessary. This should be
done by gently brushing with a soft brush in a direction away from the person
and any persons nearby. This operation should be performed outside facing
downwind.
4
Remove all the black ceramic granules.
5
Undo the two screws holding the air guide assembly in position a lift it gently
out of the firebox making sure the black ceramic granules remain in their
locating tray. Remove the two screws holding the burner and lift it out of the
appliance.
6
Thoroughly clean the burner ports.
7
The injector can be inspected without removing the control mount platform by
unscrewing it with a small box spanner or pliers.
8
To remove the control mount platform;
a
Disconnect the isolator fitting from the gas control.
b
Remove the 2 screws holding the left hand board bracket. Remove the
bracket and left hand lining board.
