3.6
CONNECTING THE BATTERY PACK - REMOTE CONTROL &
ELECTRONIC FIRE CONTROL MODELS ONLY.
3.6.1
To prevent un-necessary battery drain, the battery pack that is
used to provide the remote and electronic control function for this
product is disconnected at the factory. Prior to attempting to light the
product, can the installer please ensure that the battery pack is re-con
nected as shown in section 3.6.2 & 3.6.3 below.
3.6.2
Locate the battery pack in the support cradle at the bottom R/H side of
the firebox / burner assembly.
3.6.3
The wire and connecting plug from the battery pack should then be
connected into the supply wire running from the control board. See Fig
19 below.
Fig. 19
3.6.4
Replace the battery pack into its mounting cradle below the burner.
3.6.5
On RC models, fit the PP3 battery to the remote handset by removing
the rear cover and connecting the battery to the connecting plug.
Replace the cover on the handset.
21
Battery
Pack
Connecting Wire
Connecting
Plug
