6.0 Repairs and Replacements
6.0
Repairs and Replacements
6.1
Safety Warning - Disconnection from Power Supply
Immediately switch the product off in the event of unforeseen
circumstances (e.g. large amount of smoke). Allow the product to return
to room temperature before inspection.
Always ensure that the product is disconnected from the electrical supply
before repair work is carried out.
Caution
: Double pole/neutral fusing may be used in this product.
6.2
Panel Removal
Disconnect the product from the electrical supply.
Side Cover
. The complete right-hand side cover may be removed. Remove the screws
at the back that fasten the side cover to the rest of the casing. Push the section
backwards a few millimetres only, then ease it sideways (to the right) off the main case.
Disconnect the earth (ground) wire.
When reassembling take time and care in locating the tabs on the right of the front
control panel into the matching slots in the side cover. Remember to reconnect the
earth wire.
Internal Element Cover
. Open the door. Loosen the screw holding the internal side
cover. Pull the cover forward a few millimetres and lift it off to the left.
6.3
Temperature Controller Replacement
Refer to the controller instructions for more information on how to replace the
temperature controller.
6.4
Control Sensor Replacement
Disconnect the product from the electrical supply and remove the side cover and
internal element cover. See section 6.2.
Make a note of the connections to the temperature controller. Disconnect the
connections.
Disconnect any fixing clips or screws inside the product's chamber and remove the
sensor.
Re-assemble with the new sensor. Take care not to damage the head by rough
handling.
18
