INSTALLATION
B000882
INSTALLATION WITH SPINLOCK
Conventional assembly. (Instrument is put into the drill hole from the front).
The panel width may be within a range of 0.5 to 20 mm. The drill hole must have a diameter of 53 mm [B].
WARNING
•
Do not drill holes or ports in load-bearing or stabilizing stays or tie bars!
•
Note the necessary clearance behind the drill hole or port at the installation location. Required mounting depth: 65 mm.
•
Drill small ports; enlarge and complete them, if necessary, using taper milling tools, saber saws, keyhole saws or files.
Deburr edges. Follow the safety instructions of the tool manufacturer.
1.
Different bezels may be installed as alternatives to the
supplied front ring. In this case, gently remove the
bezel using a screwdriver [A] and install the new bezel
on the instrument and press it on until it is flush with the
instrument glass.
Note: the bezel cannot be used after removal since it
can be damaged.
IMPORTANT: if installing a chrome bezel, make sure to
configure the device BEFORE installing it, as the
metallic particles contained in the chrome material
might affect the NFC performance!
2.
Create a circular hole in the panel considering the
device dimensions. [B]
3.
Remove the spinlock and insert the device from the
front. [C]
4.
Adjust the spinlock ad shown in picture [D] according
to the panel thickness
5.
Carefully screw in the spinlock by hand at least two
turns.
6.
Insert the connector.
A
B
C
D
Summary of Contents for VL FLEX 52 INDUSTRIAL
