CONFIGURATION
B000882
4.
SET UNITS AND INSTANCE
Define the unit for the displayed value if more
than one is available (see “Supported
Configurations” table).
Set the instance for the displayed value (e.g.
Engine No. or Tank No.) so that the VL Flex will
also show it on display.
Note: the instance defined is also used by the VL
Flex in case the data is received from NMEA
2000®.
5.
CONFIGURE THE ALARM
For some gauge types it is possible to set an alarm
(see “Supported Configurations” table).
You can activate or deactivate the alarm by using
the App switch.
Once active, it is possible to set a threshold for it
in the dedicated field.
The threshold unit is the same unit defined in the
step before.
Note: the alarm threshold direction (active above
or active below) is statically defined (see
“Supported Configurations” table).
6.
CALIBRATE THE SENSOR
By default, the VL Flex device will assume the
data is received via NMEA 2000®, so the
analogue inputs are switched off.
If the sensor is connected via analog port
(resistive or frequency) you can configure it by
activating the input through the App switch.
Note: based on the gauge type(s) defined, the
App only allows to activate the related analogue
input (see “Supported Configurations” table).
In case a dual screen layout is selected (two
values), it is possible to choose which data to
configure as analog input.
Summary of Contents for VL FLEX 52 INDUSTRIAL
