User Guide
4
LEDs
Top-mounted LEDs
Rear/Top Panel
Booting / Power ON
Power port
Button on
the top
Ethernet port
USB Port
Reset
Booting recovery partition
Booting application partition
System has booted but firmware
not started
Firmware has started
Red
Connect the supplied power
adapter here
Multifunctional user button
Use a standard LAN cable (RJ45
connector) to connect your router
to the port.
The connector is a USB host with
support for mass storage devices.
Resetting the device to Factory
Settings will remove all the
information about included
devices, scenes created, House
modes settings, etc.
Push and hold the RESET button at
least 5 sec (on Ezlo Secure LED
starts blinking RED), After that
your Ezlo controller will be reset to
factory defaults.
Red
Green
Blue
Yellow
Blue
Slow blinking
Slow waving
Power
Reset
LAN
