Vera Control VeraSecure, Quick Start Manual

Page: 18 / 22

Figure 2-1: VeraSecure Controller Overview
VeraSecure Buttons
Z-Wave Include/Exclude Mode
During normal installation of Z-Wave devices you do NOT need to use these
buttons.
These instructions are for manually starting Z-Wave
Include and Exclude Modes (Figure 2-1).
• Press the Select button.
• Press the Select button again. The Z-Wave light will begin blinking.
• For Include Mode, press the Sync button briefly (less than 1 second).
• For Exclude Mode, press and hold the Sync button for at least
2 seconds, then release.
Controller Reset
Reset to Network defaults - Press the Reset button 3 times in 6 seconds.
Factory Reset - Press the Reset button 6 times in 6 seconds.
The Controller will reboot.
Note: If this controller is the primary controller for your network, resetting it
will result in the nodes in your network being orphaned and it will be necessary
after the reset to exclude and re-include all of the nodes in the network. If this
controller is being used as a secondary controller in the network, use this proce-
dure to reset this controller only in the event that the network primary control-
ler is missing or otherwise inoperable (Figure 2-1).
Mic
Select
Sync
Reset
2-Way Audio