Press the M/V/S button for more than 2 seconds to store the current frequency and mode in the current storage
unit. The word Sav-** will be displayed in the upper left corner of the LCD screen.
Everytime the radio powered
on,last saved memory of band, frequency and mode will recall.
RIT/M
Tap this button once to enter or exit the receive fine-tuning and transmit fine-tuning (RIT and XIT) functions. At this
time, the upper right of the LCD screen will display RIT or XIT and the amount of fine-tuning. After entering the
fine-tuning state, press the right tuning knob to switch between receiving fine-tuning RIT and transmitting
fine-tuning XIT.
At this time, you can fine-tune the receiving or transmitting frequency by turning the knob on the right. The step
frequency of RIT is 10 Hz, and the step frequency of XIT is 100 Hz.
Pressing the RIT/M button for more than 2 seconds will change the mode. Each time the button is pressed for 2
seconds, the mode will change in the order of CW, CWR, LSB, and USB.
Change frequency step
Press the knob on the right to switch the step frequency between 100KHz, 1KHz, 100Hz and 10Hz (press the knob
for more than 2 seconds to change the step frequency in the opposite direction). When the step frequency is
changed, there is a small triangle mark above the corresponding frequency display position on the LCD screen. If
you press the big knob in the MEM state, it will get inot the VFO mode.
Select backlight mode
Press and hold the M/V/S button and the RIT/M button at the same time to enter the backlight setting state. At this
time, turn the knob on the right to change the backlight setting. There are three settings for the backlight of the
LCD screen: ON means that the backlight is always on, OFF means that the backlight is always off, AUTO is
automatic, and the backlight will automatically turn off if the radio is not operated for about 10 seconds when the
radio is selected, and the backlight will automatically turn on when the radio is operated. Press and hold the M/V/S
button and the RIT/M button at the same time again to exit the backlight setting mode.
