Venturo HT50KX, Installation & Owner'S Manual

Page: 19 / 52

22172
C200
5-13-05
11-4-08A
INSTALLATION DWG
HT40KX, HT50KX
SUPERCEDES
TITLE
DATE SECTION
CRANE INSTALLATION
HT40KX, HT50KX
BODY REINFORCEMENT
The truck body must be reinforced and outriggers provided to withstand the combined loads
resulting from lifting and the weight of the crane and boom.
The maximum combined overturning moment for the HT40KX is 45,000 ft. lbs. and for the
HT50KX is 55,000 ft. lbs.
The maximum vertical load for the HT40KX is 7100 lbs. and for the HT50KX is 9300 lbs.
CRANE MOUNTING
The crane base plate or mounting pedestal must be bolted to the body reinforcing plate with
eight (8) grade five (5) bolts of 1" dia. with either coarse or fine threads. A 6" dia. hose clear-
ance hole must be cut in this plate to allow the hoses to swing and coil freely.
ROTATION POSITIONING
The HT cranes are shipped with the boom rotated as shown on drawing 20051. It can be in
any position that pleases the user since the boom can always reach the storage and travel
position by rotating one way or the other.
HYDRAULIC CONNECTIONS
The crane is furnished with a pressure, return and a case drain hose that come down through
the center of the housing. Included in the installation kit are two hydraulic swivels and two more
hoses. These hoses and swivels are to be arranged in the compartment or pedestal below the
crane as shown on drawing 20698 (non-proportional), or 22913 (proportional) using the angle
bulkhead fittings also furnished in the installation kit. The case drain hose must return to the
tank unrestricted.
These hoses are to be connected in a relaxed position while the crane is at the midpoint of the
400 degree rotation range -- regardless of the final position of the boom during storage/travel.
The bulkhead fittings may be located on any side of the compartment relative to the middle of
rotation position.
NOTE: If you purchased one of Venturo's hydraulic packages (P/N 19294-X.XXX), you will
have received our pressure gauge kit. This kit includes a gauge, hose and bulkhead "T" fitting
and should be installed on the pressure hose.
CINCINNATI, OHIO
MFG., INC.