Venturo ET16KXX-20, Owner'S Manual

Page: 19 / 60

SECTION DATE
SUPERSEDES
TITLE
ET16KX(P)
C150
11-12-19
-
ADDITIONAL DECALS
23986
PART NO.: 17813
DECAL: OVERLOAD SENSING SYSTEM DECAL
FUNCTION: To advise operator of overload sensing system.
QUANTITY: 1
PLACEMENT: Location may vary.
CRANE IS EQUIPPED WITH AN OVERLOAD SENSING SYSTEM
1. IF OVERLOADED, THE WINCH UP, BOOM DOWN, AND (OPTIONAL) BOOM OUT
FUNCTIONS WILL AUTOMATICALLY SHUT OFF TO PREVENT INCREASED OVERLOAD.
2. ON CRANES EQUIPPED WITH AN OPTIONAL OVERLOAD ALARM, IT WILL ALSO SOUND.
3. IF AN OVERLOAD OCCURS, USE THE WINCH DOWN, BOOM UP OR BOOM IN
FUNCTIONS TO RELIEVE THE OVERLOAD.
4. THE OVERLOAD SENSING SYSTEM IS INOPERATIVE IF THE BOOM ELEVATION IS AT
THE BOTTOM OR TOP LIMIT OF TRAVEL. TO RELIEVE THIS CONDITION, RAISE OR
LOWER THE BOOM SLIGHTLY BEFORE LIFTING THE LOAD.
5. SEE MANUAL FOR TESTING OVERLOAD SYSTEM.
NOTICE - WARRANTY VOID IF DISCONNECTED
THE OVERLOAD SENSING SYSTEM HAS BEEN INSTALLED AS A SAFETY FEATURE TO
PROTECT THE EQUIPMENT AND THE OPERATOR.
DO NOT DISCONNECT THIS SYSTEM
17813-A
14459-E
THIS CRANE IS EQUIPPED WITH AN OVERLOAD ALARM SYSTEM
1. OVERLOAD ALARM HORN SOUNDS IF RATED LOAD IS EXCEEDED AT ANY REACH.
2. IF ALARM SOUNDS, RAISE BOOM OR LOWER WINCH TO REMOVE OVERLOAD.
3. ALWAYS RAISE BOOM SLIGHTLY BEFORE LIFTING LOAD. WARNING SYSTEM
INOPERATIVE WHEN CYLINDER IS COMPLETELY BOTTOMED.
4. ALARM CAN BE TESTED BY TYING DOWN BOOM WITH WINCH CABLE AND OPERATING
BOOM UP OR BY RAISING BOOM AGAINST UP LIMIT STOP.
NOTICE - WARRANTY VOID IF DISCONNECTED
THIS ALARM SYSTEM HAS BEEN INSTALLED AS A SAFETY FEATURE
TO PROTECT BOTH THE EQUIPMENT AND THE OPERATOR.
DO NOT DISCONNECT THIS SYSTEM
PART NO.: 14459 (WITH OPTIONAL ALARM)
DECAL: OVERLOAD ALARM SYSTEM DECAL
FUNCTION: To advise operator of overload alarm system.
QUANTITY: 1
PLACEMENT: Location may vary.
VENCO VENTURO INDUSTRIES LLC
CINCINNATI, OHIO
2 3 1 9 1
2 3 1 8 8
PART NO.: 23188 (RIGHT) & 23191 (LEFT)
DECAL: MANUAL OVERRIDE DECAL (ET16/18KX)
FUNCTION: To show the manual override ports.
QUANTITY: 1
PLACEMENT: Right & Left side of housing.