E - 3
Before turning on your television set for the first time, be sure to place it on a solid stable surface. To avoid
danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the
ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.
QUICK INSTALLATION
1. Connect a TV antenna or a CATV cable to the Antenna
Terminal on rear of TV.
2. Connect the power cord.
3. Press the
/ ON
button to turn on the unit.
4. Press the or button to select “Yes” or “No”, then press the
ENTER
button to confirm.
5. The unit will enter TV setting screen. Press the button to
highlight Auto Scan, then press the
ENTER
button to confirm.
6. The unit will enter auto scan setting screen. Press the button
to highlight Cable System, then press the or button to
choose the desired cable system (We recommend you pick
“AUTO”, however you might find you get improved results using
“STD”, “IRC” or “HRC” - these are different standards used
by various Cable Systems.). Then use the button to move
the highlight bar on Start to Scan and press
ENTER
button to
start. The unit will take a few minutes to finish auto scan and
all scanned channels will be stored automatically.
7 7/8"
2 3/8"
2 3/8"
TURNING ON ThE UNIT FOR ThE FIRST TIME
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
Make sure the TV antenna or CATV cable has been connected properly to the
TV ANTENNA
input jack on the rear of the system.
Proceed with auto scan?
: SELECT
"ENTER": CONFIRM
No Yes
MENU
Return
Adjust
Select
Antenna
Cable
Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
DTV Signal
:
Picture
Audio
Time
Setup
Parental
TV
MENU
Return
Adjust
Select
Picture
Audio
Time
Setup
Parental
TV
RF CH : 3
Found : 0
MENU
Return
Adjust
Select
Cable System
AUTO
Start to Scan
Picture
Audio
Time
Setup
Parental
TV
PLV76176S7_IB_UL_090723.indd 3
7/24/2009 11:52:42
