- 11 -
e) Partially tighten each screw, but do not fully
tighten the screws until all of them have been
started (see Figure 6).
f) Gently tighten each screw until they are firmly
holding the unit in place. The top front edge of
the unit should clear the overhang.
MOUNTING SUGGESTIONS
1) If your cabinet has obstructions inside it which prevent you from using the template, cut out the
corresponding area on the template, but do NOT cut out or through the screw holes.
2) If your cabinet has obstructions underneath it, which will interfere with the mounting of the unit, remove
the obstruction before mounting the unit, or find another location to mount the unit.
3) It is recommended that you wear safety glasses while drilling to prevent eye injuries.
4) For wood cabinets, you may want to mark the hole locations with a nail, pressed gently but firmly into
the wood so that a slight impression is made. This will also help keep the drill bit centered in the right
location.
5) Hold the drill firmly against the cabinet to keep the drill from “walking”.
(Continued from previous page)
c ) Insert the four selected screws through each
hole from the inside of the cabinet going down
(see Figure 5).
MOUNTING INSTRUCTIONS
Figure 5
Figure 6
d) Hold each screw head down and push the unit
and spacers onto the screws, then hold the
unit up until spacers are firmly against the
bottom of the cabinet (and fully nested within
each other if you are using multiple spacers
for each screw).
TO REDUCE THE RISK OF FIRE, DO NOT PLACE ANY HEATING OR COOKING
APPARATUS BENEATH THIS UNIT.
CAUTION
