Vents VUE 300 HB EC, User Manual

Page: 9 / 20

9 www.ventilation-system.com
HV2 HUMIDITY SENSOR INSTALLATION AND CONNECTION
CAUTION!
The humidity sensor in the exhaust air duct should be installed and connected before the unit mounting.
• Undo the screws on the front panel and remove it.
• Install the humidity sensor in the mount.
• Connect the sensor to the control unit using a cable with a connector (installed by the manufacturer).
UNIT INSTALLATION
Suspended ceiling mounting Unit floor mounting
min 900 mm
min 900 mm
min 10 mm min 900 mm
The unit can be suspended on threaded studs or fixed to a horizontal surface using anchor bolts.
Fasteners for mounting the unit are purchased separately. While choosing fasteners consider the material of the mounting surface as well
as the weigh of the unit, refer to the “Technical data” section. Fasteners for unit installation should be selected by a qualified technician.
CAUTION!
To get the best performance of the unit and to minimize turbulence-induced air pressure losses, connect the straight air duct
section to the spigots on both sides of the unit while installing. Minimum straight air duct length: equal to 1 air duct diameter on intake side
equal to 3 air duct diameters on outlet side.
If the air ducts are too short or not connected, protect the unit parts from ingress of foreign objects. To prevent uncontrollable access to
the fan the spigots may be covered with a protecting grille or other protecting device with mesh width not more than 12.5 mm.
READ THE USER'S MANUAL BEFORE INSTALLING THE UNIT.
WHILE INSTALLING THE UNIT ENSURE CONVENIENT ACCESS FOR SUBSEQUENT
MAINTENANCE AND REPAIR.
INSTALLATION AND SET-UP